Welcome to Knowledge Base!

KB at your finger tips

This is one stop global knowledge base where you can learn about all the products, solutions and support features.

Categories
All

Products-NetApp

MetroCluster Kernel table might not be completely populated after an upgrade

Applies to

  • MetroCluster
  • ONTAP 9.3P8 and earlier
  • ONTAP 9.4P2 and earlier

Issue

  • A risk called "A Metrocluster Kernel table is not populated correctly." is displayed in ActiveIQ.
  • METROCLUSTER AUSO TRIGGER FAILED Autosupport message received during ONTAP upgrade

How to troubleshoot MetroCluster check node errors

Applies to

  • MetroCluster
  • metrocluster check
  • Node errors

Description

MetroCluster check reports errors on the node object:

ClusterA::> metrocluster check show
Last Checked On: mm/dd/yyyy hh:mm:ss
Component           Result
------------------- ---------
nodes               warning
lifs                ok
config-replication  ok
aggregates          ok
clusters            ok
5 entries were displayed.

Read article

How to troubleshoot MetroCluster check aggregate errors

Applies to

  • MetroCluster
  • metrocluster check
  • Aggregate errors

Description

MetroCluster check reports errors on the aggregates object:

ClusterA::> metrocluster check show

Last Checked On: mm/dd/yyyy hh:mm:ss

Component           Result
------------------- ---------
nodes               ok
lifs                ok
config-replication  ok
aggregates          warning
clusters            ok
5 entries were displayed.

Read article

Cannot login to ATTO bridge from GUI but CLI works

Applies to

  • ATTO 7500N FibreBridge
  • Firmware 2.90

Issue

  • The ATTO bridge is not accepting logins from the GUI.
  • Otherwise, the bridge is functioning normally and logins via the serial console or telnet work with no issues.
Read article

How to configure Cisco Discovery Protocol (CDP) in a MetroCluster IP

Applies to

  • MetroCluster IP
  • CDP
  • ONTAP 9.6 and earlier

Description

This article describes how to enable CDP in a MetroCluster IP environment.

  • CDP should be enabled on all the nodes part of the MetroCluster IP prior to ONTAP 9.7
  • It is enabled by default in ONTAP for cluster ports, but must be enabled explicitly for the other ports.
Read article

MetroCluster MDV volume must be hosted on a mirrored aggregate

Applies to

  • MetroCluster
  • MDV (Meta Data Volume)
  • CRS (Config Replication Service)

Issue

  • MetroCluster MDV volume is not hosted on a mirrored aggregate.
Read article